Fresh, brackish and marine fishkeeping with Graham Reed, The Tank Whisperer. 30+ years of wet sleeves.

The Nitrogen Cycle, Explained

The short answer: fish waste turns into ammonia, which burns gills. Bacteria in your filter turn ammonia into nitrite (also toxic), then into nitrate (fairly harmless at low levels, removed by water changes). A new tank has almost none of those bacteria. Growing them is called “cycling”, and it takes four to six weeks. Skip it and you get New Tank Syndrome: fish dying for no obvious reason in the first month.

The cycle in one picture

StageWhat it isHow toxicWhat removes it
1. Ammonia (NH3/NH4)From fish waste, uneaten food, rotting plantsVery. Damages gills even at 0.25 ppm over timeFirst group of filter bacteria
2. Nitrite (NO2)Made from ammonia by those bacteriaVery. Stops blood carrying oxygenSecond group of filter bacteria
3. Nitrate (NO3)Made from nitriteLow. Keep under 40 ppm, ideally under 20Water changes and plants

The target in a healthy, cycled tank: ammonia 0, nitrite 0, nitrate under 40 ppm. Any ammonia or nitrite reading above zero means something is wrong.

Where the bacteria actually live

Not in the water. They live on surfaces, mostly inside your filter: the sponges, ceramic rings and bio-balls. That’s why you never rinse filter media under the tap (chlorine kills them) and never replace all of it at once. Swapping the whole sponge for a new one throws your cycle away. See how to clean your filter.

Those bacteria need three things: a steady food supply (ammonia), oxygen (so the filter must run 24 hours a day), and time. They grow slowly, doubling roughly once a day at best, which is why there’s no shortcut to a mature filter.

How to cycle a tank without fish (the right way)

This is the method I recommend for every new tank. No fish suffer, and it’s usually faster than cycling with fish.

  1. Set up fully. Substrate, decor, water conditioner, filter running, heater at 25 to 28 °C. Bacteria grow faster in warm water.
  2. Add ammonia. Use pure liquid ammonia sold for aquarium cycling, dosed to about 2 ppm. No ammonia? A pinch of fish food every day works, more slowly and messily.
  3. Test every two days for ammonia, nitrite and nitrate. Write the numbers down.
  4. Watch the pattern. Ammonia rises first. After one to two weeks, nitrite appears and ammonia starts falling. Later, nitrate appears and nitrite falls.
  5. Keep feeding the bacteria. Whenever ammonia reaches zero, dose it back up to 2 ppm.
  6. The finish line: you can dose 2 ppm of ammonia and, 24 hours later, both ammonia and nitrite read zero. Do that two days running to be sure.
  7. Big water change (50 to 75%) to bring nitrate down, then add your first few hardy fish the same day, so the bacteria don’t go hungry.

What a typical fishless cycle looks like

WeekAmmoniaNitriteNitrateWhat’s happening
1High00Bacteria not established yet
2FallingRisingTraceFirst bacteria working
3LowHigh (often off the chart)RisingThe nitrite spike, the longest wait
4 to 60 in 24 hrs0 in 24 hrsHighCycled. Water change, then fish

Every tank is different; some finish in three weeks, some take eight. Your test results tell you when it’s done, not the calendar.

Can I speed it up?

  • Mature filter media: the best shortcut by far. A handful of used sponge or ceramic media from a healthy tank (a friend’s, or a good local fish shop) can cut cycling to days. Only take it from a tank with no disease problems.
  • Bottled bacteria: they can help, but they don’t make a tank instant, whatever the label says. Keep testing.
  • Warmth and oxygen: 27 to 28 °C and good surface movement help the bacteria grow.
  • Don’t: clean the filter, use antibacterial medicines, or let the ammonia run out during cycling.

Already got fish in an uncycled tank?

It happens to most of us once. It happened on this site: from the KTF archive, fish went into a brand-new tank three days after setup and four guppies were lost in a single day. Here’s how to get through a fish-in cycle safely:

  1. Test daily for ammonia and nitrite.
  2. Change 25 to 50% of the water whenever either reads above 0.25 ppm. Use dechlorinated water at the same temperature.
  3. Feed very lightly, every other day. Less food, less ammonia.
  4. Don’t add more fish until you get zero ammonia and zero nitrite for a full week.
  5. Use a conditioner that detoxifies ammonia and nitrite (several brands do) to buy the fish time between water changes.

Signs your fish are suffering: gasping at the surface, clamped fins, red or inflamed gills, lying on the bottom. If you see those, do a water change straight away, then test.

Marine tanks cycle too

Same bacteria, same stages. In a reef tank they live mostly in the live rock and sand rather than the filter. Cured live rock or established dry rock with bottled bacteria shortens the wait. Expect four to eight weeks, and an algae bloom or two along the way. More in marine for freshwater keepers.

When a cycled tank “uncycles”

A mature tank can lose its bacteria. Common causes:

  • Replacing or tap-rinsing all the filter media at once
  • A long power cut that stops the filter (see power cuts and your tank)
  • Some medications, especially antibiotics
  • Adding lots of fish at once, faster than the bacteria can grow
  • A dead fish or a forgotten lump of food rotting out of sight

The fix is the same as a fish-in cycle: test, water changes, light feeding, until the readings are back to zero.

Your questions, answered

How do I know my tank is cycled? Dose ammonia to 2 ppm. If ammonia and nitrite both read zero 24 hours later, it’s cycled.

Do I need a test kit? Yes. A liquid kit for ammonia, nitrite, nitrate and pH costs £25 to £40, and it’s the most useful thing you’ll buy after the filter. Strips are less accurate.

The shop said 24 hours was fine. Was that wrong? Yes. Running a tank for a day or a week clears chlorine and settles the water, but it grows almost none of the bacteria your fish need.

Can plants cycle a tank? Lots of fast-growing plants take up ammonia and help a lot, but you still need the filter bacteria. Test the same way.

Why is my nitrate so high after cycling? That’s normal: it’s where all that ammonia ended up. A big water change fixes it before fish go in.

Next reads: Your first tank, step by step · Start here · Fish Health Clinic · Kit guide

Stuck mid-cycle? Post your last three test results in the comments and I’ll tell you where you are. — Graham

Get in touch I’d love to hear from you

This site uses Akismet to reduce spam. Learn how your comment data is processed.